Signal NVR2716 Uživatelský manuál stáhnout pdf (Strana 19)

- 19 -

make sure that there are two hard disks installed. One is read-write disk and the other is redundant

disk. (refer to 3.5.1)

【Length】Set the time length of each video file. 60minutes is default value.

【Pre-Record】Record 1-30 seconds before the action. (time length is decided by the code stream)

【Record mode】Set video state: schedule, manual or stop.

Schedule: Record according to the set video type (common, detection and alarm)and time section.

Manual: Click the button and the according channel is recording no matter the channel in any state.

Stop: Click the stop button and the according channel stops recording no matter the channel in any

state.

【Period】Set the time section of common recording, The recording will start only in the set range.

【Record type】Set recording type: regular, detection or alarm.

Regular: Perform the regular recording in the set time section. The video file type is “R”.

Detect: Trigger the “motion detect”, “camera mask” or “video loss” signal. When above alarm is set

as opening recording, the “detection recording” state is on. The video file type is “M”.

Alarm: Trigger the external alarm signal in the set time section. When above alarm is set as opening

recording, the “detection recording” state is on. The video file type is “A”.

Note: Refer to chapter 3.3 to set corresponding alarm function.

3.1.2 Playback

Refer to chapter 2.5.2.

3.1.3 Backup

You can backup the video files to external storage through setup.

Note：The storage must be installed before the file backup. If the backup is terminated, the

already backup can playback individually.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 50 51

Žádné komentáře

Signal NVR2716 Uživatelský manuál Strana 19